Victor Mole and Gopher Sonic Spike - Outdoor Mole and Gopher Repellent - M9012 - Chemical Free Solution - 2 Pack Sonic Spikes

- Repel Moles & Gophers ? This repellent device uses sonic frequencies to penetrate the soil and humanely drive away moles and gophers - Pulses Every 30 Seconds ? This device emits sonic frequencies every 30 seconds, so moles and gophers never get used to the sound and vibrations - Powerful Protection ? The spikes work in a circular pattern, approximately 95 ft in diameter. That’s up to 7,500 sq ft of coverage per sonic spike - Mow-Over Design ? The spike can be installed flush with the ground, allowing you to mow your lawn and walk around your yard without obstructions - Long-Lasting ? Each spike will run for approximately 4 to 6 months on a set of 3 “D” batteries (not included); rechargeable batteries not recommended

From the manufacturer

Victor Sonic Spike

Removable Battery Sleeve

How to Use

Safely send moles and gophers scurrying from your yard unharmed with this Victor Sonic Spike. When placed in the ground and activated, sonic pulses penetrate the soil, emitting a sound which is highly irritating to moles and gophers who are virtually blind and overly sensitive to sound and vibrations. Climate permitting, leave the sonic mole and gopher repellent in the ground to repel new generations of pests.

The mole and gopher sonic spike is designed with a convenient removable battery sleeve for trouble-free battery replacement. A Spike will work for 4 ? 6 months on one set of alkaline batteries*. Spike must be used continuously for 7-14 days before moles and gophers start to move away from the area.

Be sure to insert the Spike into the soil so that the cap is flush with the ground to avoid tripping hazards and the chance of hitting it with a lawnmower. Effectiveness depends largely upon soil type: dry, sandy or peat soil does not conduct the sonic waves easily. Moist clay is the best conductor of sound. To use, follow these steps: To open, unscrew YELLOW cap counter-clockwise. Remove battery cartridge and insert batteries. Re-insert the battery cartridge into the Spike. If installation is correct, you will hear vibrating sound within 15 seconds. Tighten the cap securely to keep moisture out. Make pilot holes prior to inserting the spikes. Do not hammer it into the ground, insert Spike until the cap is flush with the ground.